Four Signs of a Water Heater Failure

Posted by on Dec 23, 2015 in Gas Water Heater Repair Corona CA, Water Heater Repair Corona CA

Hot water heaters usually complete exactly what they are intended to and often go undetected until one needs a Corona Water Heater Repair. But, some of the problems which come up can be prevented by having regular servicing by a pro. Make sure to pay attention to your natural gas burning water heater, because a few of the issues that could develop could be pricey and unsafe for friends and family and pets. Here, we are explaining four indications that your gas water heater may possibly need to be replaced.

Dripping WaterWater Heater Repairs Corona CA

In cases where there is water on the ground close to your water heater or leaking out of a pipe, you might have to upgrade the hot water heater. However, dependant upon exactly where the water is and how much there is, you could be just fine. In case the hot water heater is leaking water out of a pipe and there exists a little bit of water on the ground beside the water heater, it’s most likely the T&P valve. The temperature and pressure valve removes excess water vapor from the hot water heater, this steam becomes to water and will come out from the hot water heater by means of a pipe on the side of the tank. Whenever this is the situation, it’s absolutely natural and important for the heating unit to operate accurately. Don’t try to move the T&P valve and never block it. If you are concerned with the amount of water that is coming out from the pipe, call an expert! If perhaps the dripping water is originating from the bottom of the tank, it’s pretty much undoubtedly time to get a different water heater. When the water heater heats water the metal tank expands and contracts, and this activity might result in cracks and little fractures, that will eventually bring about leaks. When this occurs, it will be time to purchase a new system.

Rust

Around the pipes coming out of the water heater one can find pipe fittings that must be sealed tight to be able to keep the pipe in place and keep water from leaking out of the opening. In the event you are observing rust around such pipe fittings, water is seeping out of the hole. Even though it is not a major leak and will not likely bring about immediate damage to the hot water heater, in the event that the issue isn’t fixed, significant and pricey complications will eventually appear.

Burn Markings

If perhaps you are observing burn marks at the bottom of the water heater, there are 2 potential problems. Even so, each of them happen to be rather significant and each of them necessitate a professional. One problem might be with the venting. If the venting is clogged or was set up improperly, it may cause the exhaust gases to come back into the property. This is unsafe and can bring about sickness or fire if left alone for long. However, this might not mean you need to replace the water heater, which is a good thing. Another potential problem with burn marks might be that the flue pipes inside of the hot water heater are plugged. This could cause numerous hazardous problems and, sadly, the water heater will have to be replaced asap.

Yellowish Flame Color

Gas burning water heaters have a blue flame underneath the tank whenever it is running. But, in case you’re seeing that flame is an orange or yellow color, rather than blue, the burner isn’t functioning appropriately and is going to need to be looked at by a professional.

There are a lot of problems which can develop with gas burning water heaters, although together with consistent upkeep and annual examinations, you can prevent the need for an unexpected water heater repair in Corona that may possibly be pricey. Contact us today if you detect anything uncommon with your water heater!